SIGLENT SDS1000D Manuel de service télécharger pdf (Page 16)

Service Manual

Auto Setup

SDS1000D Series Digital Storage Oscilloscopes have auto setup function, which can identify the

type of waveform and adjust controls to produce a usable display of the input signal.

AUTO is the auto setup button.

Table2-1 Auto setup function menu:

Option Introduction

（Multi-cycle

sine）

Auto set the screen and display several cycle

signal.

（Single-cycle

sine）

Set the screen and auto display single cycle signal.

（Rising

edge）

Auto set and show the rising time.

（Falling

edge）

Auto set and show the falling time.

（Undo

Setup）

Causes the oscilloscope to recall the previous

setup.

There are four measure parameter will be displayed in the screen. Auto set determines the trigger

source based on the following conditions:

●If multiple channels have signals, channel with the lowest frequency signal.

●The input frequency must be higher than 10Hz, and the amplitude must be higher than

8MV

Table 2-2 Auto setup function item

Function

FunctionFunction

Function

Setting

SettingSetting

Setting

Acquire Mode Adjusted to Sampling

Display Format Y-T

Display Type Set to Dots for a video signal, set to Vectors

for an FFT spectrum; otherwise, unchanged

Vertical Coupling Adjusted to DC or AC according to the input

signal

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Pas de commentaire

SIGLENT SDS1000D Manuel de service Page 16