SIGLENT SDS1000D Manuel d'utilisateur télécharger pdf (Page 140)

132

Check the trigger mode on the trigger interface whether or not in the

“normal” or “single”, and check the trigger level is whether or not over the

wave range. If yes, please put the trigger level to the middle position or set

the trigger mode to the “Auto” position. In another hand, you could choose

the “Auto” button to set up automatically.

6. After the Acquisition is set to Averages or Display Persistence time is

set too long, the waveform refreshes slowly.

It is normal in these settings

7. The signal is displayed as ladder like waveform

(1)This phenomenon is normal. The time base maybe is too slow .you

should turn the horizontal SCALE knob to increase horizontal resolution to

improve the display.

(2) Maybe the display Type is set to “Vectors”, You could set it to Dots

mode to improve the display.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 153 154

Pas de commentaire

SIGLENT SDS1000D Manuel d'utilisateur Page 140